One Vortex edge lost, what to do?

Here's the place if you've got something to ask about the world's best, and bestselling, oars.

One Vortex edge lost, what to do?

Postby mikedepetris » July 27th, 2016, 6:10 am

Hi, we have only a pair of C2 sculls with vortex edges and one got lost. What would you suggest to do? I am thinking to leave it as it is, as it seems there is no sensible difference with rowing with only one device on.
Ho would you remove the other one with no risk of damage?
Would it be affordable and worth to put on another one, considering that it is the only vortex blade in the boathouse and we do not travel around, so it would need a shipment for the replacement (Italy)?
mikedepetris
Paddler
 
Posts: 4
Joined: September 22nd, 2015, 10:55 am

Re: One Vortex edge lost, what to do?

Postby ArmandoChavezUNC » July 27th, 2016, 9:28 am

Unless you're racing at a very high level, I don't think you'll notice any adverse effects and considering the difficulty in getting one shipped I would just not worry about it.
Image
ArmandoChavezUNC
6k Poster
 
Posts: 848
Joined: November 18th, 2008, 11:21 pm

Re: One Vortex edge lost, what to do?

Postby c2KevinS » July 27th, 2016, 9:37 am

Mike - It is quite an easy job and it should be straightforward to get the part and glue. They have the added benefit of protecting the outer edge of the blade from damage. Filippi is our Italian oar distributor and they can get you the parts you'd need (http://www.filippiboats.it). There are instructions for replacing vortex edges on the C2 website (http://www.concept2.com/service/oars/oa ... schematics). Please don't hesitate to contact us at rowing@concept2.com if you have trouble.

If you decide to just remove it, there's little chance of damaging the blade. Use a flat chisel and pry the vortex edge off. Once off, use the chisel to scrape any remaining glue off the blade surface.
Concept2 Engineering Staff since 2010...
purveyors of speed and lactate located in Morrisville, VT
User avatar
c2KevinS
Paddler
 
Posts: 6
Joined: January 20th, 2011, 12:26 pm
Location: Morrisville, VT


Return to Concept2 Dreissigacker Oars

Who is online

Users browsing this forum: No registered users and 1 guest