Page 1 of 1
disassembling model D rower
Posted: September 8th, 2012, 4:47 pm
by larkl
Hi,
I need to take my C2 model D apart for allergy reasons - I need to get it apart enough so that I can rinse any part that's accessible to air.
I'm not sure how to do this.
I took part of the casing of the fan off, and saw a bolt holding the fan on. Is it ok to undo this bolt?
How about squirting water from a garden hose through it?
thanks
Laura
Re: disassembling model D rower
Posted: September 8th, 2012, 4:54 pm
by Citroen
Everything you need should be at
http://www.concept2.com/service/indoor- ... schematics
If not then call C2 for advice toll free at 1-800 245 5676
Re: disassembling model D rower
Posted: September 8th, 2012, 5:22 pm
by Atorrante
Hi Citroen,
I have another question for you. Can you tell me why, if I make a new workout (PM3) with a paceboat of 1060 Kcal/hour, when saved, it is saved with 1054 Kcal/hour instead. This is happening in my new Model D received yesterday. I don't remember my old D Model w PM3 did that.
Thank You,
Manuel
Re: disassembling model D rower
Posted: September 8th, 2012, 5:41 pm
by Citroen
Atorrante wrote: Can you tell me why, if I make a new workout (PM3) with a paceboat of 1060 Kcal/hour, when saved, it is saved with 1054 Kcal/hour instead. This is happening in my new Model D received yesterday. I don't remember my old D Model w PM3 did that.
Thank You,
Manuel
Could be a bug in the firmware. Or it could be a rounding error. Or it could be a feature of converting base 10 numbers to base 16 (or binary) which is what is used internally in the monitor.