Page 1 of 1
Total meters/time PM3
Posted: November 1st, 2006, 8:08 am
by Rubix Cube
Is it possible to see how long a concept2 is used in total?
So not the lifetime meters on the logcard but the total meters/time ever rowed on that indoor rower
Posted: November 1st, 2006, 9:12 am
by Tyn
Hi
I've asked this question some time ago on this forum,
The answer then was: No
If you never use a logcard then the pm3 will show life time metres,...
I think!!
Posted: November 2nd, 2006, 12:23 am
by coggs
Which Monitor? On the PM3 go to:
*Utilities
*Product Information
*More Information
and you can get total meters rowed on the PM (not the log card) at the bottom of the screen
On the PM2 I think there was a combination of holding down two button that would give you total miles.
Posted: November 2nd, 2006, 8:13 pm
by Citroen
You need to upgrade the firmware to V90 or above.
So pull the firmware loader for V97 from
http://www.concept2.com/us/support/soft ... nloads.asp
(It takes about 5½ mins to run that.)
The lifetime metres shows up on the product info menu with V97.