Dyno - lubing short "loop" chain: how do you do it?

Not sure where you should be posting? Put it here.
Post Reply
User avatar
5k Poster
Posts: 579
Joined: April 20th, 2013, 2:05 am
Location: St Louis, MO

Dyno - lubing short "loop" chain: how do you do it?

Post by Ombrax » January 30th, 2019, 9:16 pm

I just got a Dyno, and it turns out that it's one of the earlier production models that doesn't have a hole on top of the monorail (behind the push-seat) to allow access to the short chain.

If you have a similar early Dyno how do you oil that chain?

One solution suggested by C2 is to drill a hole to create an access port, but doing so would probably drop some metal chips onto the chain, which I would like to avoid if possible.

I'm hoping that someone out there has figured out a relatively painless way to do this, and will same me the hassle of going up the Dyno learning curve all alone.


Post Reply